NOTE: The distance between the modular battery cabinet (s) and the UPS must not exceed 100 m. Contact Schneider Electric for installations with a longer distance.
Floor Space Requirements. Preferably the UPS has to be installed close to the loads. If the distance between the load and the UPS is higher, we must consider the voltage drop based on the distance of the cable and suitable action like oversizing the cable needs to be considered.
The battery cabinet must be installed adjacent to the power cabinet. The following diagram shows the equipment layout for a typical new indoor Macrocell site. Notes: The cabinets may be placed with zero clearance to the rear wall. The cabinets may be placed with zero clearance to the side wall, however some clearance is recommended.
Choosing the right cables for UPS installations is critical. Incorrect cable selection can lead to problems like overheating, fire risks, and early failure. It's also important to pick the best installation method and routing. Use the same cable size for input and output, ensuring it can handle the thermal current continuously.
How to choose the right ups?
Preferably the UPS has to be installed close to the loads. If the distance between the load and the UPS is higher, we must consider the voltage drop based on the distance of the cable and suitable action like over sizing the cable needs to be considered. It is important that adequate floor space has to be provided for the UPS.
How much space do you need for UPS?
Keep at least 1 meter of clear area in front of the unit for service personnel. Confirm that the floor can support the UPS and batteries, considering the unit's weight, which varies based on capacity and type. What is the general arrangement of UPS system? Most UPS units operate optimally at temperatures below 40°C (104°F).
Where should the ups be installed?
The UPS installation location should be chosen with care. The type and amount of site preparation required will vary according to the specific location and its relative location to the connected load. Preferably the UPS has to be installed close to the loads.