This paper demonstrates how the typical methods used to select and specify power density are flawed, and provides an improved approach for establishing space requirements, including recom-mended density specifications for typical situations. In order to provide a full energy eficient solution with regards to data center cabinet-level power. Wall-mount boxes run roughly 200×200×120 → 800×600×300 mm; floor cabinets about 1600–2200 mm H, 600–1800 mm W, 300–600 mm D; small plastic/FRP boxes top out near 300 mm class. Catalog H×W×D is outside size; check back-panel and usable/protected space (gaskets, returns, studs. This section includes the specifications for constructing and building out of Telecommunications Equipment Rooms (MDF/IDFs) to be used for supporting telecommunications and other special systems. The following topics are discussed: The list below describes typical configurations that could comprise a communications equipment site.
[PDF Version]
How much power is allowed per cabinet?
The design target average power per cabinet is 5 kW. The peak power allowed in any cabinet is 12.5 kW as long as the pod power does not exceed 50 kW for all 12 cabinets combined. The total indoor space required by this design is 25,320 ft2 (2,352 m2).
Almost every data center has some variation of power among cabinets. It is common to find cabinets operating from 50 watts (a network switch with patch panels) up to 30 kW (fully loaded high performance blade servers). This represents a range of 60 to 1 in power consumption.
The specification is hierarchical and modular, so that different rooms and zones can have different density requirements. The specification comprehends that IT cabinets within data centers have different power requirements, and that these requirements may not be well-defined in advance.
How wide should a working space be in front of electrical equipment?
Article 110.26(A)(2)—Specifies that the width of the working space in front of the electrical equipment shall be the width of the equipment or 30 inches (762 mm), whichever is greater. The goal is to prevent a worker from being unduly crowded when testing or maintaining equipment. The width of the working space is a factor regarding worker safety.