Lightning protection specification for inverter transformers of communication base stations

Lightning protection (strikes with indirect effects) for telecommunication stations by lightning arresters, is applicable for all electrical networks. It is also compulsory to provide protection against lightning strikes with direct effects by placing a lightning arrester (near the top of the

or a large private subscriber / consumer (tertiary industry, others). Lightning protection (strikes with indirect effects) for telecommunication stations by lightning arresters, is applicable for all electrical networks.

These individual elements of an LPS should be connected together using appropriate lightning protection components (LPC) complying with BS EN 50164 or IEC 62561 series. This will ensure that in the event of a lightning current discharge to the structure, the correct design and choice of components will minimize any potential damage.

The earthing network of an RBS should be formed by a ring loop surrounding the tower, equipment room and fence, at a minimum. The mean radius re of this ring loop should be not less than l1, as indicated in Figure 1 and this value depends on the lightning protection system (LPS) class and on the soil resistivity.

Lightning protection level is used to design protection measures according to the relevant set of lightning current parameters. Complete system used to reduce physical damage due to lightning flashes striking a structure. It consists of both external and internal lightning protection systems.

If the antenna is installed on the top of telecommunication tower, e.g., antenna positions 1 of Figure 29, it is considered to be impacted by or exposed to direct lightning strikes. Refer to [IEC 62305-3] for detail information about the protection angles and volume protected by an air termination system.